Description: This Lennar Knowledge Base guide will help get the Command Line Interface (CLI) access on the Windows and MAC devices, to troubleshoot the issues related to the RUCKUS ICX-7150-C12P Switch and Access Points. Environment: Product(s): RU...
Issue Description: Due to a power outage/power spike, the RUCKUS ICX-7150-C12P Switch went to a state that we call ‘boot mode’ that is not able to boot up properly. This is the reason the RUCKUS ICX-7150-C12P Switch will be unable to transmit power (...
Description: Complete the factory reset of the RUCKUS Access Points and configure them with a new Wi-Fi network or Service Set Identifier (SSID). Environment: Product(s): RUCKUS R510 Access Points.Software / Firmware Version: This could be on any ve...
Issue Description: This issue may happen when your RUCKUS ICX-7150-C12P Switch starts running on the Routing code (SPR). The Switch should run on the Switching code (SPS) to avoid these issues for Lennar home users. Due to a power outage/power spike...
Description: Usually, for Lennar RUCKUS devices troubleshooting purposes, there are some instances where we need the IP Addresses of the RUCKUS ICX-7150-C12P Switch and RUCKUS R510 Access Points to access them using a Web browser Graphical User Inter...
Issue Description: Upgrade RUCKUS ICX-7150-C12P to a stable Unified Forwarding Image (UFI) version for Lennar Home users to avoid any issues. Environment: Product(s): ICX-7150-C12PSoftware / Firmware Version: 08.0.95g Introduction: Below is the p...
Description: In certain situations, performing a physical factory reset or hardware reset of the RUCKUS ICX-7150-C12P Switch becomes necessary that restore the Switch to its factory default settings. This RUCKUS Lennar Knowledge Base article aims to ...
Description: Upgrading the RUCKUS Unleashed R510 Access Points (APs) to a stable version for Lennar Home users to avoid any issues. Environment: Product(s): RUCKUS R510 APsSoftware / Firmware Version: 200.15.6.12.304 (For now and subject to change...
Issue Description: This issue occurs when the RUCKUS ICX-7150-C12P Switch ports get into a disabled/off state and do not transmit the Power to the Access Points via its Power over Ethernet (PoE) ports. The switch light status will be in a normal stat...
Issue Description: Due to a power outage/power spike, the RUCKUS ICX-7150-C12P Switch went to a state that we call ‘boot mode’ that is not able to boot up properly with an Amber/Orange light on the "SYST" and a Green light on the "PWR". When reset (h...
Description: This RUCKUS Lennar Knowledge Base self-help article is designed to assist Lennar Home users in effectively configuring, optimizing, and setting up the RUCKUS and other networking devices for uninterrupted Internet connectivity. Custome...
Issue Description: This issue may happen when your RUCKUS ICX-7150-C12P Switch starts running on the Routing code (SPR). The Switch should run on the Switching code (SPS) to avoid these issues for Lennar home users. Due to a power outage/power spike,...
