Hi, Support teamI got a zone director 1100 with version of 9.5. 0.0 build156, this unit always goes into the setup wizard mode when powering up/powering cycle, which means that I need to finish the setup wizard for each powering up. Is there any con...
I have 2 1200 zonedirectors that I am unable to factory reset them. When turned on the status and power lights turn green immediately. with an ethernet cable connected to port 1 both port lights turn green but do not blink.I have pushed the f/d but...
A customer using zd-1200 is having a problem.Hello. I am writing this because a customer using zd-1200 is having a problem.The customer is the administrator of zd-1200 and several network infrastructures.However, the customer is currently experiencin...
Hello.The customer is currently using 2 ZD-1200s with smart-redundancy configured, but one of the active mode devices is experiencing a problem, so one of the standby devices is operating in active mode.The device with the problem is operating in ac...
Hello.As the title says, this is a post about a customer who is using 2 ZD-1200s in a smart-redundancy configuration.The customer informed me today that there was a problem with the zd-1200 active device they were using. Fortunately, there is no serv...
