RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.
You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.
Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.
Please visit https://support.ruckuswireless.com/technical_support_bulletins/642 for details Bulletin OverviewThis Technical Support Bulletin describes a software limitation regarding the SZ upgrade from SZ 6.1.2.0.487 Patch-3 GD Release to SZ 7.0.0 P...
Dear Valued Customers, This communication is intended for our Partners/Customers who rely on Device Registrar Service (DRS) to onboard devices (AP/Switch) onto Smart Zone Controller.Please be aware of an upcoming change to the Device Registrar Servic...
HiRandom APs got continuously disconnected while iam checking events i got this. SZ version 3.5.1.0.862
Hello friends, I have a problem, I currently cannot see the code 236 events, this information is useful to determine problems with the radius. But I see that I no longer have these logs. Previously I could see them. I don't know how long I've had thi...
Greetings, The following revised RUCKUS SmartZone product guides have been published to the RUCKUS Support Portal. See the “New in This Document” section for details on the most recent changes. RUCKUS SmartZone (ST-GA) WLAN Management Guide, 7.0.0ht...
On a Smart Zone 100 controller with firmware: 6.1.1.0.959I am trying to setup a WLAN with a WPA password and with a L3 policy that restricts access to our corporate network and L2 policy that restrict access to only certain MAC Addresses.The problem ...
