RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.
You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.
Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.
Please visit https://support.ruckuswireless.com/technical_support_bulletins/642 for details Bulletin OverviewThis Technical Support Bulletin describes a software limitation regarding the SZ upgrade from SZ 6.1.2.0.487 Patch-3 GD Release to SZ 7.0.0 P...
Hey guys,I have a quick question pertaining to the two instances I listed above. I'm currently building out a server, and was wondering if it's wise to install both instances on a single VM (obviously I'd leave some cushion on specs for these to work...
I installed a 6.0.0.0 vSZ on a Hyper-V, the deployment worked fine the config website starts up. After I finish the configuration via webUi the vSZ uses "halt -f -d -n" and get stucked at this point the VM is doing nothing... I was trying to install ...
I want to downgrade a SZ144-D dataplane from 6.0.0.0.1331 to 5.2.2.0.317. Apparently there is no way to upload older firmware directly to the dataplane; only upgrade is available and trying to downgrade to an older version with upgrade commands lead...
Hi Everyone, I have a SZ-100 setup with a single port group setup. We have 46 APs currently and are expecting to add 30 more at another location on campus. Currently, the primary wireless LAN lives on the same VLAN as the APs and the SZ-100 (t...
