Ruckus vSZ stuck on halting after configuration.

[rok_piavec]

I installed a 6.0.0.0 vSZ on a Hyper-V, the deployment worked fine the config website starts up.

After I finish the configuration via webUi the vSZ uses "halt -f -d -n" and get stucked at this point the VM is doing nothing...

I was trying to install the vSZ via Shell got the same issue.

I have no option to save the configurations

any ideas?

[quinn_henry · Accepted solution]

This is most likely happening because you haven't assigned enough resources to the VM as per the setup guide. I believe the minimum for <100 devices is 2 cores, 14GB RAM.

As long as you are at or better than those specs, the VM should configure fine and reboot once complete.

[rok_piavec]

@quinn_henry

Worked for me 🙂 thanks