Hey Folks,is there a way to generate a report for less and most used Access Points in vSZ 6.1.2 ?The available report types are very limited, and not what i want to get.ThanksPeter
Hey Folks,we are using vSZ in a VMware Environment, and since deployment the virtual Hardware Version of the VM is Compatibility ESXi 5.1 and later (VM version 9). Is it possible to upgrade the virtual Hardware?RegardsPeter
Hey Folks,is there special trick configuring Ethernet Ports in SmartZone v-SZe Controller?When i select a Port and click "Configure" we always get this error: What I am missing?RegardsPeter
When trying to access the advanced Portal of LiMan an error appears:Entering a description of the Problem and clicking Send, we receive a NDR:There seems to be a problem with mail forwarding.Please check.Thanks
From time to time we notice a higher cpu usage on our vSZ-e Controller as usual, when it is not rebooted for a while:After a reboot the usage goes down again:the last days the usage rises again in two steps without any noticable reasons:Current Syste...
It goes in this direction, but i have to select every single access point from the drop down list. While having over 200 APs it takes a lot of time Would be better being able to select an AP-Group e.g.
We would like to generate a report of connected devices over specific time periods, so we can determine whether certain access points can be removed or relocated to areas with higher or denser usage
the upgrade process itself isnt an issue. we did it a lot of times. but in the past we noticed some linux appliance dont like it if the hardware version is upgraded to a newer level, hence i was asking if there are already some experiences, cause the...
Hello Vasanth,We are using:Controller Version 6.1.2.0.487Control Plane Software Version 6.1.2.0.253AP Firmware Version 6.1.2.0.2104with AP Patch: 6.1.2.0.2230Yes i mean the ESXi VM Version to a newer Version:RegardsPeter
