Please visit https://support.ruckuswireless.com/technical_support_bulletins/642 for details Bulletin OverviewThis Technical Support Bulletin describes a software limitation regarding the SZ upgrade from SZ 6.1.2.0.487 Patch-3 GD Release to SZ 7.0.0 P...
The following RUCKUS SmartZone 6.1.2 product guides have been published on the RUCKUS Support Portal.The PM can share the links below as needed for release announcements. SmartZone 6.1.2 (LT-GD) Public API Reference Guide (ICX Management)SmartZone 6....
I installed a 6.0.0.0 vSZ on a Hyper-V, the deployment worked fine the config website starts up. After I finish the configuration via webUi the vSZ uses "halt -f -d -n" and get stucked at this point the VM is doing nothing... I was trying to install ...
I want to downgrade a SZ144-D dataplane from 6.0.0.0.1331 to 5.2.2.0.317. Apparently there is no way to upload older firmware directly to the dataplane; only upgrade is available and trying to downgrade to an older version with upgrade commands lead...
Hi Everyone, I have a SZ-100 setup with a single port group setup. We have 46 APs currently and are expecting to add 30 more at another location on campus. Currently, the primary wireless LAN lives on the same VLAN as the APs and the SZ-100 (t...
Hello everyone! I just recently started getting set up with my new Virtual SmartZone controller. I have the controller itself licensed (but I haven't applied my AP licenses yet). I'm looking under the "System Info" page, and found the total capaci...
