New Contributor III
since ‎01-18-2022

User Statistics

  • 14 Posts
  • 0 Solutions
  • 5 Kudos given
  • 1 Kudos received

User Activity

I've got a Wired 802.1x implementation with a ruckus switch as the Radius client and a Microsoft NPS acting as the Radius server.The below config line on the switch is the one causing me a lot of grief and I see a constant error showing up on Event V...
I've put ports 1/1/1-1/1/5 Untagged and they're assigned to a vlan 10 that I created.Now when i run the command,dot1x enable ethernet 1/1/1, it errors out in:Error - MAC-AUTH/Dot1x cannot be enabled on UNTAGGED port 1/1/1 on non-system default vlan.D...
Is there a CLI command to Power off my Ruckus ICX 7450 switch?
ICX-7450Just created a pool and when trying to Active the pool, I run the "deploy" command, and this errors out for some reasonError:----------------------------------------------------------------------Invalid input ->ip dhcp-server pool vlan10dhcpT...
Ruckus ICX 7450 -I've noticed that when I boot from Primary vs Secondary, the running-config is different so I was wondering if each flash has its own config file, or do they share the config file? I have 08.0.95f and 09.0.10 (different firmware) on ...