I have 2 R310 devices in office.Both was working fine.I upgrade both to 200.7.10.2.339.Master was upgrade successfully but another one was fail.I see slave device was disconnected in dashboard. OMG!I upgraded slave R310 to 200.7.10.2.339 manually but...
Hello,I've worked with some wireless hardware from other vendors before but I've read a lot of good things about Ruckus and I'm looking into using it for an upcoming project and would appreciate some guidance.I need to provide connectivity in a 60' ...
Trying to connect Ubiquity M2 client radios to a Ruckus R600. The UBNT radios connect just fine but will not pass traffic. I can get into the radio interface once the client radio connects but nothing will pass through the lan side. So I put back my ...
So I have 2 Unleashed T710's that I am trying to get working with another Unleashed T710 that is setup as a master. Firmware is up to date on all 3 units. I have factory reset the units, but once it gets the info from the master, it reboots and keeps...
Hi to all.i ́m newbie with ruckus. I have some questions.I ́m now on a ZD1200 installation with this version of software installed: 9.10.0.0.218With r500, that are compatible with the last Firmware version.Could you tell me if its recommended to go t...
