CommScope RUCKUS Community Forums

SmartZone Per-User Shape · 09-12-2023

Hello We have virtual SmartZone, version is 6.1.1.0.959 and I would like to apply per-user shape and not sure how I can do it. In setting I found one place where it should be:I tried to apply L3 Access Policy but it didn't shape traffic. How I can ap...

irakli_gvishian · 08-03-2023

Hello, we have several Ruckus ICX7150 with SPS08095f.bin version of firmwareAlso I have implemented MSTP because I have a lot of vlans and I would like to enable on ports BPDU-Guard and not sure how I can enable It, I mean what is the command? With p...

irakli_gvishian · 11-09-2022

Hello,We have 2 Ruckus ICX 7250, which are stacked. Version of Firmware is SPR08030h. We would Like to do upgrade up to SPR08090mc (Non-UFI). I'm interesting about upgrade procedure and have some of questions:1 - Do I need to load new Firmware to bot...

irakli_gvishian · 11-03-2022

Hello,We have 2 Ruckus ICX7250 switches, which are stacked. Firmware is in Router mode, Version is SPR08090mc.bin (Non-UFI). There is the configuration: stack unit 1module 1 icx7250-48-port-management-modulemodule 2 icx7250-sfp-plus-8port-80g-module...

irakli_gvishian · 10-24-2022

Hello,We have 2 Ruckus ZD1200 in HA mode. I would like to configure mail alert if any AP goes down. Test Notification works, but I tried to restart AP but there is no alert appeared. As I see configuration is correct. What can be problem?

Re: SmartZone Per-User Shape · 09-12-2023

Thanks @Syed for reply, it's strange because we have very old virtual smartzone (version is 3.4) in different location and there we can do per-user rate limit...

irakli_gvishian · 08-03-2023

@BenBeck thanks for your reply,Code version of core is SPR09010f.binIssue with "enable" is with core. I have enable Tacacs+ authentication and authorization for different levels of access and if enter "aaa authentication enable default local" in case...

irakli_gvishian · 11-10-2022

@BenBeck Yes, it's answer on my question. Thanks for your time and assist!

irakli_gvishian · 11-10-2022

@BenBeck Then I would like to assume steps:0 - Save configuration (Write memory)1 - Load to the stack new Bootrom image2 - Load to the stack new Firmware (08080f Non-UFI)3 - Reboot stack4 - Load new Bootrom to the stack5 - Load to the stack new Firmw...

irakli_gvishian · 11-10-2022

@BenBeck Thanks for your response. Regarding Non-UFI, I have on another location also 2 Ruckus ICX 7250, they are also stacked and firmware on them is SPR08090mc.bin (Non-UFI). There is screenshot of CLI:Also there screenshot of downloaded files, you...

CommScope RUCKUS Community Forums

User Statistics

User Activity

SmartZone Per-User Shape

Ruckus ICX MSTP

Stack ICX 7250 Firmware Upgrade

Ruckus ICX7250 Stack Replacement

Ruckus ZD1200 Mail Alert

Re: SmartZone Per-User Shape

Re: Ruckus ICX MSTP

Re: Stack ICX 7250 Firmware Upgrade

Re: Stack ICX 7250 Firmware Upgrade

Re: Stack ICX 7250 Firmware Upgrade