Hello everyone,
In this article, I will explain how vRIOT Broker IP can be configured by different ways and some basic to debug the AP-vRIOT connectivity.
Below three ways can be utilised to add APs to the vRIOT :
1) Manual command from RKSCLI.2) AP...
Introduction :
This article is focused on explaining the requirement and process to move AP's from your existing ZD platform to virtual platform "vSZ/SZ". This would cover your pre-requisite and supported user scenario's. Since there are a lot diff...
Hi Neeraj,
There has been no known issue with roaming on Ruckus so far, yes regarding the FT roam failure we can debug. Also allow me to explain the roaming process breakdown. The below process is done for roaming on WiFi and all the packets are init...
Hi Kkuzen,
You could try below and that should help.
1) AP recovery SSID methods depending on release version
https://support.ruckuswireless.com/articles/000008823
2) How to factory reset or factory default different type of Ruckus Access points?
htt...
Hi Neeraj,
Quick question, while you deployed these APs was a site survey performed ? Roaming is a client decision where it decides whether to roam or not and to which AP as per the network RF. Usually 99% of time roaming issue is due to the reason t...
Hi Kedo,
So you want to change the aaa auth method to pap from default chap and I assume you want this for your web auth WLAN. This command needs to be executed on AP CLI and if there are bulk APs you can create an AP CLI script and push command via ...
What is the user account in use ? If its not admin then you might have a user that has only access to perform certain limited things in which moving AP to another zone is not added (access for a single zone etc)
Best Regards
Vineet
