These applications are useful if you want to access CLI of networks devices, such as Ruckus devices.
Here is where you can download:
Putty:https://www.putty.org/
Mobaxterm: https://mobaxterm.mobatek.net/download-home-edition.html
1-For SSH or Telne...
A common Lennar environment is a router and one or more APs connected to the ICX-7150, this can include multiple smart devices connected through cable or Wi-Fi.
Some symptoms when the ICX 7150-c12p is running Routing code:
Smart devices like Amazon's...
How to perform an upgrade on the Access Points (unleashed version) using the Unleashed dashboard
Please go to: unleashed.ruckuswireless.com or use the IP address of the Master AP
Use the management credentials.
Admin usernames and passwords for the ...
This is a reference on how to connect devices in the most common Lennar setups
There must be a modem and a router to connect the ICX 7150-C12p, it must be plugged into one of the twelve ports (the middle ones).
Note: It can be a 'modem' and 'router'...
Step 1
View your available networks and Connect to "Configure. Me"(Where you see 1807D0, these are final 6 digits of your AP’s MAC address - This will be unique)When the device is connected to configure.me it takes a bit of time before the device to ...
Hello @Tillery
Hope you are doing well !
We need to factory reset the network from the "Access Points" and reconfigure it correctly.
Here is a short guide with the most common setups for Lennar home users:
https://community.ruckuswireless.com/t5/RU...
Hi @samanthacook176
Since you are on higher version you dont need to install the 8080f version you can go ahead and install the 8095G firmware version.
You can start from this step:
From the USB guide it will be from step "20" as reference
Best Re...
Hi @jcsny18
If the access via IP address is not possible here is a guide how to access to the Switch via console (cable access between your PC to the ICX 7150-C12P) in this case we need a USB type C to USB standard or Console cable Rj45 to USB.
How...
