Hello RUCKUS Lennar Community, Greetings of the day!!! We have recently introduced the RUCKUS Lennar Knowledge Base self-help guides portal section within this Community for Lennar Home users. It includes the most common issues and some technical gui...
Hello RUCKUS Community Team, Greetings of the day!!! This post is with regards to the announcement details we posted on this Community forum (on 06-22-2023) regarding the iPhone with iOS 16 version login issue unable to reach “unleashed.ruckuswireles...
Welcome to your primary source for RUCKUS Lennar SmartHome Support! Before posting please review these suggestions. Please be sure to read the RUCKUS Community GuidelinesPlease be considerate and respectful. We understand you may be frustrated, but p...
So, I have two APs and I disconnected everything except one. I reset the one and held for 15 sec. Everything rebooted and ssid showed as needed. I did a quick set up and the last step was finish and the message in the subject was displayed with a exi...
I went through the Steps to reset my Unleashed ruckus unplugging one of the 2 and leaving just one AP. I went through the steps reset it and then configured the new wifi and now I have two Wi-Fi with two different names. The new one I created and the...
I have a R510 AP that came with my Lennar home. It was working great and then it was not. The POE port is only working when powered by plugging it into a wall outlet. I am using a Ubiquity POE switch and checked the configuration of the port. It has...
After a power spike my switch booted from secondary firmware (SPR) instead of (SPS). I tried “copy flash flash secondary” but received the below error. I then tried within the GUI and now after a “boot system flash primary yes” it only boots the seco...
I have been having an issue with my R510 AP going in and out for my internet since a power outage. I moved into my lennar home in 2019, so i am sure it needs to be updated. However, when i used the free software to get the IP address (it showed rucku...
