Hard to believe we have already completed the first half of 2024. Which means we have compiled the stats from the community and have identified our top contributors! And the winners are Squozen and y2! On behalf of the entire RUCKUS Community, thank ...
Welcome to the RUCKUS Pack! The RUCKUS Networks Community is a place to ask questions, resolve issues, learn, exchange ideas, and connect with your peers. The Pack includes a diverse range of members who are passionate about sharing and collaborating...
Hello! I want to upgrade our 5.1.2 2xvSZ+2xvDP to 5.2.1 latest. But I found from SZ-5.2.1-UpgradeGuide-RevA-20200731.pdf on page 23 this note: "For remote APs connected over a VPN, the tunnel MTU must be reduced to 1400 (acceptable range is: 850 th...
Hello, I am having reports of some problems related to the unavailability of WLANs when the APs lose contact with the ZD3000. The discovery is made via L3, and the authentication of the WLANs are all local, that is, everything should work, since the...
Hi, I hope someone can help. I have a working set of Ruckus P300’s on a project. They work fine and I get a good speed across the wireless bridge, will all my VLAN’s reaching across to the remote switch and other devices. However when I VPN into t...
Hello Guys, could you ask a question? Can an R320 be unleashed with R310?In the R320 datasheet it can support up to 128 devices, and the R310 only 25. Is it possible to configure the R320 as a controller for R310 models, for example? In case of R320 ...
I factory reset the R510 which was already in use/online in Smartzone 3.6 and the AP firmware was 3.6.2.0.254. I deleted the AP from the existing zone and hoping after factory reset the AP, it will show up on the staging zone again, but it never did.
