RUCKUS Indoor and Outdoor Access Points (APs)

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

How to troubleshoot ZoneFlex 7962AP after a factory reset ?

A hard reset was done to a Zone flex 7962 AP using the external pin hole to revert to Factory set up. AP is powered but does not rediscover the ZD. The original FW was 9.4. After a firmware upgrade to 9.6.0.267 to match a working AP and being dire...

Connect seperate subnets without NAT

I have x20 Zoneflex7343's managed through a ZoneDirector in my school (i'm responsible for the IT) and things have run well for two years :-) NOW we have purchased 90 iPads and have a problem... We only have 253 IP's on our subnet and as the local ...

Mesh Roaming Issues

We got a small'ish mesh running on 7762-s outdoor APs and a 1100 ZD. The roaming between APs takes about 30-40 seconds on average. This can't be normal, and I can't seem to correct it. Any advice/help please?

Mesh Roaming Problems

Is it possible to set the roaming threshold, and if so.....where exactly? Current roaming on a small 7762-s mesh takes about 30-40 seconds to do handover....

ZoneDirector system packet drop rate error message

I've started seeing System packet-drop rate [1626734%] exceeds threshold [90%] on a ZoneDirector running 9.7.0.0 build 220. Searching Google I found a post from May 2003 saying it had been fixed in 9.5 and above: http://forums-archive.ruckuswireless....

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

2

2

1

1

1