Hi!I'm getting close to a working solution for accessing Barco Clickshare device on a wired VLAN, from all Wifi networks on separate VLANs/subnets/IP ranges.I created internal firewall rules for inter-VLAN routing. I can see the Baro device available...
Does anyone else has experience this as well?The weird thing is it the VPN tunnel was able to be connected/established but then no internet connection after that. I know it's not my Meraki MX Firewall blocking it because everything is working fine if...
I have 11 SSIDs/WLANs configured on my Zone Director.I am not getting all of these showing up on all 17 of my access points.I have a variety of r510, h510 and r310 access points which according to the spec sheets can do up to 16 SSIDs.All of the WLAN...
Ruckus H510 keeps dropping 2.4GHz connectionslots of these lines in log:WAL DEV reset, wifi0 rx 1, tx 1, reset =1 reason 2WAL TX timeout wifi0 sig=fa33 txq 0 7 1 3
Hi i have Rukus h510 after upgrading firmware to unleashed am not able to remove access point previously configured it is still enable and
