hello everyone,I am using ruckus outdoor AP T610. But I could not access to it to configure. My devices:1. Access Point outdoor AP T6102. PoE TPLink TL-POE150SMy diagram:Switch <---> PoE <--> PoE port in AP T610.then I see the light PWR is green, and...
Is there a way to disable the 5Ghz on APs?Either via ZD or individual AP config?The reason I ask is that the APs are only able to do 16 SSIDS (8 on 2.4GHz and 8 on 5Ghz)I would like 10 SSIDS however am unable to do this with 5Ghz using half of the AP...
Dear all,Does anyone can help to enable the Port 2 on R610 (picture as below) and how to use it as Link Aggregation? Thanks a lot!
GOOD MORNING, HOW CAN I LOAD FIRMWARE WITH SSH TO AP R700. SINCE THE LOOKING DOES NOT START CORRECTLY. POWER LED KEEPS BLINKING. THE DEVICE ANSWERS ME (192.168.0.1) CORRECTLY BUT DOES NOT START THE SYSTEM. THANK YOU
COMO PUEDO CARGAR FIRMWARE CON SSH A AP R700. YA QUE AL PARECER NO INICIA CORRECTAMENTE. LED POWER SE MANTIENE PARPADEANDO. GRACIAS
