RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.
You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.
Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.
We flashed a brand new R510 AP, first on the network, so it will be Master, with Unleashed firmware 200.6 and after reboot, it shows the message "Building the Unleashed Network. It may take a few minutes" and has done so, and nothing else, for a few ...
I just found out that I may have access to some gently used R700 AP's in the future. At home, I'm currently running a couple of OpenMesh AP's with their free lifetime cloud-based management console. I wanted to add a third AP, but OpenMesh was purc...
Trying to learn how to set up my system to maximize the 1000/1000 speeds I now get from my cable provider. My iPhone only seems to get 125-160. I have a Zone Director 112 and 8 AP's (4-zf 7372 & 4-zf 7363) Thank you
Ever since we switched from rubbish consumer WAPs to Ruckus Unleashed (3x R510, 1x R500), I have never been able to get AirPrint working. It used to work fine with the old WAPs but no matter what I do, it just doesn't work with the Unleashed setup. I...
I currently have a R610 and a R510. The R610 is the master and is hardwired with the R510 setup in a mesh configuration. I did a packet capture today and I noticed that the R610 kept arping for the gateway address. Is this normal activity? or is some...
