RUCKUS Indoor and Outdoor Access Points (APs)

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

connecting a VF2811 & VF2111

I am connecting a VF2811 to the router with a LAN cable and setting in another room the VF2111. My goal is to use the WLAN in this other room where otherwise I do not get any signal. Both Ruckus (2811 & 2111) see each other and get all lights in gree...

signal autometic disconnecting after 15 to 20 min, setup " ZD1200, r720 with 802.3at power"

while using r720 and ZD1200(ver- 10.1.0.1553) as controller and powering AP's with 802.3at.the ap's are placed in instute where at a time around 60 students connect to the access point But 15- 20 min of using Wi-Fi singnal went after a few seconds it...

We were supplied with 14 R320 and a zonedirector 1200, why is the R320 not showing as Mesh supported?

Are the R320 mesh compatible on the zonedirector?

Second Ethernet Port on R720 Unleashed for Ethernet to Switch Possible?

Is it possible to set up Router>R720 2.5g Input>Switch on 1g ethernet output on the Ruckus Unleashed firmware? I'm trying to run from the output to a switch so that I can change out some switches in the future without disrupting the wifi.In the futur...

R700 no link on poe interface blinks on pwr dir

Weird issue with my R700.It powers up on POE from my POE switch.It's using about 7W.I get no link on the PoE interface, so the nic is down.The ap has been powered on for 30min, and the PWR and DIR leds are blinking.Anything I can try out?I tried rese...

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

2

1

1

1

1