I am running newest Unleashed firmware. Was trying to do a factory reset but lost power before procedure can complete. Now I can't access GUI via 192.168.0.1 and CTL flashes fast. Can this unit be recovered?
Thanks.
That's the power supply I got. I have two of them and both behaves the same. It has been a day since I installed it and saw this warning. I'll give some more time then. What should I check for if problem persists? Thanks.
Thanks, got it working now.
I have ran into another issue. I am using AC power supply (740-64277-001/ 48V .75A). In GUI, I got a warning stating "not enough electricity power provided". Do I need to configure the AP to recognize its getting AC po...
Thanks for the reply. Another issue to verify. 802.3bt comes either as Type 3 or 4, do I need to get type 4 since I've read that R720 only uses 2 twisted pairs for power and type 3 only supports 30W for two twisted pair while type 4 supports more?Th...
Hi Abi,Thanks for the info. I went over that information already.Below are two links that has R720 with 802.3bt support along with PoH/UPoE, Injector and 48VDC for full power.https://docs.arris.com/bundle/ap-110.0-indooruserguide/page/GUID-8E8F8B00-...
