RUCKUS Indoor and Outdoor Access Points (APs)

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

802.11v BSS Transition Management check

Hi I am trying to see if 802.11v is enabled CLI command rkscli: get bss-trans-mgmt wlan1 when I enter this I getBSS Transition Management:enabledOKrkscli: get station wlan32 infoMAC Addr AID Rate RSSI VLAN Idle ERP State Flags RecvSigStrengt...

R720 802.3bt support

I have read conflicting information (datasheets) on whether or not R720 supports 802.3bt. Can someone verify if R720 indeed supports 802.3bt?

Creating a MESH with multiple AP's

I have recently bought in to Ruckus APs. Some config points below before the questionInitially, I was using a R310 200.7.10.202.94I have now purchased 2x R610'sThe internal IP range is 192.168.1.X The ISP router is 192.168.0.XIn between the WAN and L...

Tunneling SSID's using a VSCG Controller

Moving from applianced based 3K Zone Directors ( which have been running flawlessly for about 100 years in production so far ) to Virtual Smartzones, I have a question regarding runnng a VSCG within a Vmware Cluster. I would like some clarification ...

Remote capture using linux

Hi all.... Does anyone already implemented a remote capture for linux using the sniffer mode available on Ruckus AP's? Using wireshark on windows I have the "Remote Interfaces" feature... However, I need to perform a capture using linux command line ...

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

2

1

1

1

1