RUCKUS Indoor and Outdoor Access Points (APs)

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

What should my poe switch ourput be for a Ruckus R319

Hi,I have a neatgear poe+ switch and a Ruckus R310. All is working fine and I wanted to check what the power should be for this unit to ensure its getting full power and best performance.Currently the switch is showing 3.5 Watts66 mA53.1 Volts.I'd r...

standalone firmware update for 7982 AP? currently at 104.0.0.0.1347

Is this the most mature firmware for stand-alone operation? If not, where to find? I am holding "Standalone AP upgrade via CLI" article (#1551) which suggests using TFTP. The Download package from site today is 9.6.1.0.15BL7 and that sounds incomp...

R750 target fail detect

I'm getting frequent restarts for one of the R750 AP's with error: "target fail detect". Sometimes the AP is restarting with reason: application reboot. 6 clients connected. 802.3at PoE is fine. Firmware is: 200.8.10.3.243 Speedtest between master ...

Is it economiccally feasible or even possible to convert a Ruckus R750 ZoneFlex Access Point (901-R750-US00) to the Unleashed firmware?

I looked at the catalog when comparing all the different ax/wifi6 access points, and the R750 was the cheapest I could find, but it's ZoneFlex. I found the ZoneFlex FAQ but it read more like marketing material and I don't feel like I got a clear prag...

Ruckus R700 converted to standalone mode and now DIR light is blinking

I installed the standalone firmware on a R700 AP that was running the Zone Director firmware. Now the DIR light on the AP is blinking green. How would I stop the DR light from flashing with the standalone firmware installed?

Related Self-Help

Find More Solutions