CommScope RUCKUS Community Forums

Slave Ruckus R510 Issues Connecting to Master

After updating firmware to latest version, only the master was updated. This messed up connection to the slave AP - slave AP showed as disconnected. After trying to factory reset multiple times (hold down reset button until power light is red) the R5...

The ethernet interface configuration on our Ruckus r610 keeps resetting.

We have a Ruckus r610 with the latest unleashed firmware.  After SSHing into it, I used command:set interface eth0 type general untag none vlans 1,3VLAN 1 is for access and VLAN 3 is our guest network.  This setup works for around 2 weeks, then out o...

Random AP R510 reboots - [application reboot]

Ruckus R510 AP reboots randomly.I have 6 AP's in the network and only this one reboots. I have checked the switch that it is connected to and there are no problems with connectivity. There are also 2 PoE cameras connected to it and they do not drop a...

P300 backhaul bridging topology

Hi everyone, need your advice and experience sharing. P300 (P-to-P/P-Multi-P bridges) can support Mesh topology in outdoor backhauling Network !? RAP->MAP->eMAP->MAP !? also, can be use-it for wireless end users ?Regards,

Can I add R610s to my R500 unleashed network?