I setup an R310 in gateway/router mode and noticed that I am limited to ~150mbps download and ~5mbps upload. I subscribe to and consistently get 200mbps download and 30mbps upload speeds otherwise. Is this a known limitation when the access point is ...
I have an R310 running on the cloud and I am trying to turn off the LEDs (PWR, CTL, 2.4, 5). I can't seem to find this enable/disable option anywhere. The AP is in a bedroom so at night it is distracting.
Where is the option to optimize for compati...
Just updated an Unleashed network to 200.2. The guest network is no longer bringing up the authentication screen on Apple devices, users are forced to open a web browser which can cause confusion and unsatisfactory guest experience. I've tried checki...
Randomly I am having issues with APs that require a reboot to regain Internet. In order to access the GUI IP I have to roam to another AP. When I remain connected to the problem AP and run a LAN scan, it shows only connected devices to that IP and I ...
I'm setting up an ACL for a WLAN to rate limit iOS devices and allow all others by default. When I apply this method, all non-iOS clients disconnect and cannot connect to the WLAN. I'm under the impression that all non-iOS devices should be able to c...
The R310 and R320 do not support mesh. If you were to enable the option, I just think they would not connect via mesh when you unplug the ethernet cable.
I don’t know what DHCP range your router is giving out. I would guess not less than 100, can you try 192.168.0.99? It is difficult to troubleshoot further for me online, I would recommend doing a hard reset of your switch by pressing the reset button...
Try assigning it an IP address. This needs to be a free IP address that is not already in use. Only you can know that, either by logging into your router or running a LAN scan such as Net Analyzer on an iPhone. Let’s try our luck and assign it the fo...
