VRoIT Firmware is not available from the support site, tried to search if there is announcement on portal for its disappearance but didn't find any. I am in middle of deployment and not able to find it on the support site. Are there any plans to stop...
I tried to enable POE on ICX 7450-24P, but it doesn't show any output.Core#show po poe inline power information port Show port security power-savings-statistics Power savings statisticsCore#show p...
Hi @lienmonden ,There are two ways of deploying this, Lets assume you have Site A and Site B.Type 1.Run Site to Site VPN between the two Sites and NAT internal IP of SZ's and AP's so that their subnets are reachable across the Sites, Firewall Rules h...
Hi @lienmonden ,You would get the internal IP displayed in the output of "get scg" command, if you don't want that to be seen, the other way is configuring the NAT on the firewall instead vSZ, provided you allow all the ports that needs to be open fo...
Dear sheraz_raees,Please correct me if I misunderstood your requirement. You would not be able to load balance two different ISP's using Ruckus Smart zone. You need to use a Firewall or a device like Peplink to load balance two ISP's. Hope it helps!!...
Dear MH,From your above conversation, I understand that the APs are running on Unleashed firmware. Please make sure you reset all the APs to default by pressing the reset button on the back of the access point for about 5-10 seconds and take one AP a...
Dear pawelm,Roaming in scenario of APs between two different Zones is not seamless, but in case of same zone is seamless.Hope it helps!!!Regards,Abilash PR.