Hello, I had stopped working on it as I was able to just have it operational. I am once again trying to update the firmware after a power outage and cannot seem to update to current ufi firmware.
Switch will not update firmware and when in cli it says it is in read only. Also when I try to configure ssl there is no start up config file. tried multiple times and says the same thing. when i show flash it shows "Compressed Pri Code size = 259764...
Switch will not update firmware and when in cli it says it is in read only. Also when I try to configure ssl there is no start up config file. tried multiple times and says the same thing. when i show flash it shows "Compressed Pri Code size = 259764...
Hello,The method I was using to upgrade was tftp and once I rebooted after the upgrade I would get that fail and a bunch of errors not being able to find a file directory or a config file. I’ve posted it earlier in the thread of all the fails. When I...
I was getting UBISF errors and could not load a config file. Should I do a full factory reset and attempt to do the recommended steps as mentioned above?ICX7150-C12-Switch#UBIFS error (ubi0:0 pid 688): ubifs_check_node: bad node at L EB 10
Below is the information requested.ICX7150-C12-Switch#show versionCopyright (c) 2017 Ruckus Wireless, Inc. All rights reserved.UNIT 1: compiled on Apr 6 2020 at 22:29:25 labeled as SPS08080f(25976488 bytes) from Primary SPS08080d.binSW: Version 08.0....
Hello, I had stopped working on it as I was able to just have it operational. I am once again trying to update the firmware after a power outage and cannot seem to update to current ufi firmware.
I performed software recovery steps per the guide and executed the reload command. The above string is what i got after the reload. Why is it showing next to the versions SPR/SPS 08080d.bin?