cancel
Showing results for 
Search instead for 
Did you mean: 

Cannot update icx7150

Rkeiser
New Contributor

Switch will not update firmware and when in cli it says it is in read only. Also when I try to configure ssl there is no start up config file. tried multiple times and says the same thing. when i show flash it shows "Compressed Pri Code size = 25976488, Version:08.0.80fT211 (SPS08080d.bin)
 Compressed Sec Code size = 25976488, Version:08.0.80fT211 (SPR08080d.bin)
 Compressed Boot-Monitor Image size = 786944, Version:10.1.15T225
" It wont take the actual image 08090f to upgrade to ufi.

26 REPLIES 26

Hi @Rkeiser 

Greetings! 

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it. 

Your prompt response would be greatly appreciated.

Thank you for your attention to this matter.

 

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community

Rkeiser
New Contributor

Hello, I had stopped working on it as I was able to just have it operational. I am once again trying to update the firmware after a power outage and cannot seem to update to current ufi firmware.