CommScope RUCKUS Community Forums

Hi.<Message>--------------------------------------------------U1-MSG: PoE Severe Error: Internal Device supplying power to port 1/1/5 is hot. Distribute the load so that each of the 8 ports group (ports 1-8, 9-16 etc) have equal power consumption.---...

Hi Ruckus Team.Our customers have been using ICX 7150 and 7450 as L2 POE with ver. 09.0.10e since early 2023.However, when the power is disconnected and reconnected or the switch is rebooted, the switch is stuck in boot mode or OS> prompt, and the sw...

Hello.How do I configure route-only whe interface e 1/1/x was vlan 1 member, and int ve 1 had ip address?example configuration is below.Router(config)#ip dhcp-client disableRouter(config)#no ip dhcp-client ve defaultRouter(config)#show vlanTotal PORT...

 Hi Friends.It assume it configured multiple subnet on a interfce ve 100 and needs dhcp relay at the int ve 100.Ex. int ve 100, ip add 1.1.1.1/24, ip add 2.2.2.2/24 ip add 3.3.3.3/24As a rsult of my test, relay agent ip(GIADDRESS) in dhcp packet is 1...