RUCKUS Wireless Questions and Best Practices

|

Wireless Questions and Best Practices

RUCKUS offers a number of Best Practice Guides for all aspects of Wi-Fi system design, installation, configuration, management and maintenance.

Forum Posts

Sorted by:

ASK the Pack

Announcement: 104.x (GA) Software Release for 802.11ac Wave 2 APs

Much work has gone into development of Solo AP 104.0.0.0.1347 GA firmware image for currently supported Indoor/Outdoor APs, with initial posting for 802.11ac Wave 2 AP models. This firmware includes new AP certificates, needed for continued H...

R700 not connecting with 256 QAM speeds (MCS 8, 9)

My standalone R700 will not use MCS 8 or 9 for any clients connected over the 5GHz 80Mhz AC-band. Even when the client is very close to the AP with direct line of sight, the MCS index stays at 7 with a reported Tx rate of 878Mbps. How can I get it t...

Configure two R600s - configure them to work with eachother

I have never touched a ruckus before. I have two R600's (no additional management program or device). They are both direct wired to the LAN switch. Our firewall distributed DHCP. Do I need to do anything more than just put the same SSID and pa...

Client gets IP address before authentication

We are using web authentication and the problem is that clients are getting the IP address before entering the credentials, and they can ping, telnet on to other IP's on the same subnet etc. Any ideas how solve this issue?

Guest Access Blocked

I am trying to deploy a Guest Network using ZoneDirector 9.12.2.0 build 204 and a couple T300 Access Points. I created a WLAN called FYL and everything works fine on Standard Usage. But I want to set up a captive portal page with Guest Access. It ...

Related Self-Help

Find More Solutions