Switches
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

ICX7150-C12-Switch admin username and password

Hi, I am 100% new to this and don't know much so bare with me.  On the unleashed dashboard it shows I can add my switch to it. ive also noticed I needed to upgrade my firmware to 08.0.90 or later. "was running 08.0.80(something). I upgraded the boot...

ICX7250P POE Daughterboard Replacement?

HiI have obtained a ICX7250P with 08.0.95ba Firmware The switch works normally, but the POE Module Reports:- Severe Error - Module Failed to Init. I have reloaded the Boot, Image and POE Firmware with no effect. The switch works normally, the POE ...

dan_dare by New Contributor
  • 17 Views
  • 1 replies
  • 0 kudos

Cloud Support for 7250/7450 Series

We have 16 7250/7450 switches in our network. None are stacked, all spread throughout campus. We also have 40 R710 APs on a ZD1200 controller. We are evaluating migrating this to Ruckus Cloud. For the APs, we will either keep the 710s or possibly ...

Switch not getting configuration from SmartZone

We are using a SmartZone 100 to manage our APs and are now installing ICX 7650 switches to run multi-gig APs.  These are the first Ruckus switches we have and I am having issues with them getting the configuration from the SZ. SZ is on version 5.2.1....

jason_hilt by New Contributor III
  • 37 Views
  • 1 replies
  • 0 kudos

How do I check for ECMP with ebgp?

Hi all,  I've enabled ip load sharing globally as well as maximum-paths in ebgp itself.  Checking my route table, I see only one route to my destination.  If I disable the ports, the secondary route does insert itself in the table.  Is this expec...