08-05-2023 08:02 AM
After a power outage, my Ruckus router AIR light is not blinking and nor not on. The other lights from the router are on. I have tried numerous attempts to unplug, reset and even disconnect the router from the wall and connect it again. I cannot access my network name that was created for the access point, but i can access the Frontier router. How can I reconnect to my old router name? I am having trouble accessing unleashed as well.
I have a Ruckus R320 Series Unleashed
Solved! Go to Solution.
08-14-2023 11:35 AM
Hi @Ant
Please try to access the switch via console using the below guide and share the output of the following commands.
How to console in the ICX-7150-C12P:
enable
Show flash
Show version
Please let us know if you have any queries in this regard.
Best regards,
Jayavidhya
Lennar Home Community
08-14-2023 07:47 AM
Hi @Ant
Thanks for your response.
To check this, first, we have to get access to the switch, and there are two ways to get access to the switch.
By IP address: To fix this issue, we must identify the ‘current’ IP address assigned by your local router to the switch ICX-7150-C12P
I will leave you a guide on how to perform an IP scanner on your local network to identify the switch IP address very easily.
How to find my Ruckus “Devices IP address” using free applications:
Once we identify the IP address of the switch proceed to access remotely to the device “Command Line”
How to remotely access to 'ICX 7150-C12P' or 'access points' "Network devices":
If you can access the Command line should look like this:
ICX7150-C12 Router>
enable
Show flash
Show version
Please let us know if you have any queries in this regard.
Best regards,
Jayavidhya
Lennar Home Community
08-14-2023 10:01 AM
The links don't work.
08-14-2023 10:27 AM
Hi @Ant
Sorry for the inconvenience.
Please find the below link to find the device IP address and to access the switch remotely.
How to find my Ruckus “Devices IP address” using free applications:
How to remotely access to 'ICX 7150-C12P' or 'access points' "Network devices":
Please let us know if you have any queries in this regard.
Best regards,
Jayavidhya
Lennar Home Community
08-14-2023 10:42 AM
Ok, i have went this far. where do I go from there? or is this correct?
08-14-2023 11:12 AM
I found the ip and applyed it to the other photo i provided.....