09-11-2023 09:28 AM
After a power outage we have no internet connection through the Wi-Fi network hooked up with Ruckus. The network shows up on my available networks. I have reset the switch, but doesn’t help. All the lights are green and steady on the switch and the piece on my ceiling.
I am very technical not savvy so I need help in very simple terms.
we do have internet service to our house as we have another router that is working through Spectrum.
I do not have a computer. I only use my phone and an IPad.
thank you
Barb
Solved! Go to Solution.
09-12-2023 01:34 PM
Hi @nc
Thanks for your response.
Good to hear that the issue was solved.
Please feel free to mark this case as ACCEPTED SOLUTION.
Also please let us know if you have any queries in this regard.
Best regards,
Jayavidhya
Lennar Home Community
09-12-2023 08:17 AM
09-12-2023 09:04 AM
Hi @nc
To solve this issue please make sure you have internet connection from your ISP or not. Also please try to perform the physical factory reset of the access points correctly.
Please make sure you disconnect all other APs on the network and preform the Factory reset to the master AP that remains connected to the ICX-Switch 7150.
Physical Factory Reset an Access Points Ruckus
Please let us know if you have any queries in this regard.
Best regards,
Jayavidhya
Lennar Home Community
09-12-2023 10:00 AM
There is a Ethernet cord hooked from the switch to a router that is hooked to the modem. Should that remain hooked up?
09-12-2023 10:49 AM
Hi @nc
Please refer the below guide which explains the connections of the switch and the router.
Most common Setups for Lennar homes users
Please confirm whether you have internet connection from your ISP router or not.
Also please perform the physical factory reset of the access points correctly.
IMPORTANT NOTE: To perform a factory reset correctly on one of the access points, you must disconnect the rest of your other access points from the "ICX-7150-switch". For example, if you have 3 access points, you should go to the switch and disconnect 2 of the cables to turn off the "2 access points" and only leave 1 connected with which we are going to work the factory reset once you configure the access point and make sure all is good, go ahead and reconnect the other Access Points back.
Physical Factory Reset of RUCKUS Access Point:
Ruckus Unleashed Set-up using your Mobile:
Ruckus Unleashed Set-up using Web:
https://www.youtube.com/watch?v=j8I5aVwMNMg
Password recovery setup:
https://www.youtube.com/watch?v=sqnG8fupaLk
Please let us know if you have any queries in this regard.
Best regards,
Jayavidhya
Lennar Home Community
09-12-2023 11:43 AM
After unplugging the modem,router,switch and Ruckus, one more time. Everything is working!!
thank you for your help. Sorry about being so unintelligent about these things
nc