After being unplugged I noticed that my switch was not booting properly and that the light for "system" is a solid amber color. After some searching on forums, etc I believe that the boot config file has been corrupted or along those lines.
I attempted to follow this YouTube video (https://www.youtube.com/watch?v=RHriOYYD_iI&t=11s) to flash a new image to the switch but I am unable to provide keyboard input while using HyperTerminal or SecureCRT. I have ensured that the settings are configured as Baud 9600, data bits 8, parity none, stop bits 1, and flow control none. I have tried this while using a RJ-45 cable to serial and serial to USB. I have also tried using a USB-C to USB-A cable.
Here is the log that displays when the switch is connected to secureCRT:
Booted from partition 2 DRAM: Validate Shmoo parameters stored in flash ..... OK
ICX7150-12 (POE), PVT1 SYS CPLD VER: 0x4 Released Ver: 0xa
device 0 offset 0x0, size 0xc0000 Enter 'b' to stop at boot monitor: 0 device 0 offset 0x0, size 0xc0000 bootdelay: === Booting image from Primary
NAND read: device 0 offset 0x0, size 0x2000000 7 ecc_errors after reading 18b8000:18b9c00 iproc_nand_read_page returned 2 NAND read from offset 0 failed -22 0 bytes read: ERROR ## Loading kernel from FIT Image at 70000200 ... Bad FIT kernel image format! ERROR: can't get kernel image! could not boot from primary, no valid image; trying to boot from secondary device 0 offset 0x0, size 0xc0000 BOOTING image from Secondary
NAND read: device 0 offset 0x4000000, size 0x2000000 1 ecc_errors after reading 58b8000:58b8800 iproc_nand_read_page returned 2 NAND read from offset 4000000 failed -22 0 bytes read: ERROR ## Loading kernel from FIT Image at 70000200 ... Bad FIT kernel image format! ERROR: can't get kernel image! ICX7150-Boot>
As I stated above, I cannot provide keyboard input to enter "b" to stop at boot monitor.
At this point I am unsure what to do or even if I assumed correctly that the config file become corrupted during the power outage.
I have no networking experience so I hope that someone can help me with the issue I am having.
Note: after fixing the issue of the Switch been stuck in boot mode, please perform an upgrade to the code 08095g UFI and upgrade both partitions with the switching code file named SPS08095gufi.bin, so perform the software recovery using the code 08090k with the upgrade image file named SPS08090k.bin, then when the switch is back to normal upgrade to the file SPS08095gufi.bin for both partitions primary and secondary.
1.Upgrade a Switch ICX-7150-C12P using a USB flash drive
Thank you for the quick reply! I will try the suggestions when I get home. I noticed in one of the guides they say they will be using the 08090k firmware. I read somewhere that in order to upgrade to 08090+ you must first have 08080f installed. Is this still true? I am unsure what firmware my ICX had installed prior to the boot loop.
I tried following the guide you posted above. When I get to the Putty step, putty is not registering keyboard strokes, similarly to what I said in my original post regarding hyper terminal and secureCRT.