Firmware Upgrade for ICX7150-C12 Switch - Need help locating Firmware version and help upgrading

[MiSNemesis]

I have a ICX 7150 since 2020 and was never upgraded.  I am at a lost as to how to locate the version and then what upgrade is necessary to use.  Any help would be appreciated.

[MiSNemesis]

The APs are still not light up.

SSH@ICX7150-C12 Switch#show inline power

Power Capacity: Total is 124000 mWatts. Current Free is 124000 mWatts.

Power Allocations: Requests Honored 0 times

Port Admin Oper ---Power(mWatts)--- PD Type PD Class Pri Fault/
State State Consumed Allocated Error
-----------------------------------------------------------------------------
1/1/1 On Off 0 0 n/a n/a 0 n/a
1/1/2 On Off 0 0 n/a n/a 0 n/a
1/1/3 On Off 0 0 n/a n/a 0 n/a
1/1/4 On Off 0 0 n/a n/a 0 n/a
1/1/5 On Off 0 0 n/a n/a 0 n/a
1/1/6 On Off 0 0 n/a n/a 0 n/a
1/1/7 On Off 0 0 n/a n/a 0 n/a
1/1/8 On Off 0 0 n/a n/a 0 n/a
1/1/9 On Off 0 0 n/a n/a 0 n/a
1/1/10 On Off 0 0 n/a n/a 0 n/a
1/1/11 On Off 0 0 n/a n/a 0 n/a
1/1/12 On Off 0 0 n/a n/a 0 n/a
-----------------------------------------------------------------------------
Total 0 0

SSH@ICX7150-C12 Switch#

[Imran_ruckus]

Hi @MiSNemesis 

Thank you for the response and the update.

Please enter the below commands once you log in to CLI and share the output.

Note: Hit Enter to accept each command 

enable

show version

show flash
show inline power 
show interface brief

Please let me know if you have any queries in this regard.

Thank you again for your patience.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[MiSNemesis]

SSH@ICX7150-C12 Switch#show version
Copyright (c) Ruckus Networks, Inc. All rights reserved.
UNIT 1: compiled on May 6 2022 at 23:24:50 labeled as SPS08095g
(31457280 bytes) from Primary SPS08095g.bin (UFI)
SW: Version 08.0.95gT211
Compressed Primary Boot Code size = 786944, Version:10.1.24T225 (mnz10124)
Compiled on Thu Apr 21 02:08:52 2022

HW: Stackable ICX7150-C12-POE
==========================================================================
UNIT 1: SL 1: ICX7150-C12-2X10GR POE 12-port Management Module
Serial #:FEK3203P15K
Software Package: BASE_SOFT_PACKAGE
Current License: 2X10GR
P-ASIC 0: type B160, rev 11 Chip BCM56160_B0
==========================================================================
UNIT 1: SL 2: ICX7150-2X1GC 2-port 2G Module
==========================================================================
UNIT 1: SL 3: ICX7150-2X10GF 2-port 20G Module
==========================================================================
1000 MHz ARM processor ARMv7 88 MHz bus
8 MB boot flash memory
2 GB code flash memory
1 GB DRAM
--More--, next page: Space, next line: Return key, quit: Control-c

-----------------------------------------------------------------------------------------------

SSH@ICX7150-C12 Switch#show flash
Stack unit 1:
NAND Type: Micron NAND 2GiB (x 1)
Compressed Pri Code size = 31457280, Version:08.0.95gT211 (SPS08095g.bin)
Compressed Sec Code size = 31457280, Version:08.0.95gT211 (SPS08095g.bin)
Compressed Pri Boot Code size = 786944, Version:10.1.24T225 (mnz10124)
Compressed Sec Boot Code size = 786944, Version:10.1.24T225 (mnz10124)
Code Flash Free Space = 1111490560
SSH@ICX7150-C12 Switch#

-----------------------------------------------------------------

SSH@ICX7150-C12 Switch#show inline power

Power Capacity: Total is 124000 mWatts. Current Free is 124000 mWatts.

Power Allocations: Requests Honored 0 times

Port Admin Oper ---Power(mWatts)--- PD Type PD Class Pri Fault/
State State Consumed Allocated Error
-----------------------------------------------------------------------------
1/1/1 On Off 0 0 n/a n/a 0 n/a
1/1/2 On Off 0 0 n/a n/a 0 n/a
1/1/3 On Off 0 0 n/a n/a 0 n/a
1/1/4 On Off 0 0 n/a n/a 0 n/a
1/1/5 On Off 0 0 n/a n/a 0 n/a
1/1/6 On Off 0 0 n/a n/a 0 n/a
1/1/7 On Off 0 0 n/a n/a 0 n/a
1/1/8 On Off 0 0 n/a n/a 0 n/a
1/1/9 On Off 0 0 n/a n/a 0 n/a
1/1/10 On Off 0 0 n/a n/a 0 n/a
1/1/11 On Off 0 0 n/a n/a 0 n/a
1/1/12 On Off 0 0 n/a n/a 0 n/a
-----------------------------------------------------------------------------
Total 0 0

SSH@ICX7150-C12 Switch#

------------------------------------------------------------------------------------

SSH@ICX7150-C12 Switch#show interface brief

Port Link State Dupl Speed Trunk Tag Pvid Pri MAC Name
1/1/1 Up Forward Full 1G None No 1 0 78a6.e13f.aab8
1/1/2 Down None None None None No 1 0 78a6.e13f.aab9
1/1/3 Down None None None None No 1 0 78a6.e13f.aaba
1/1/4 Down None None None None No 1 0 78a6.e13f.aabb
1/1/5 Down None None None None No 1 0 78a6.e13f.aabc
1/1/6 Down None None None None No 1 0 78a6.e13f.aabd
1/1/7 Down None None None None No 1 0 78a6.e13f.aabe
1/1/8 Down None None None None No 1 0 78a6.e13f.aabf
1/1/9 Up Forward Full 1G None No 1 0 78a6.e13f.aac0
1/1/10 Down None None None None No 1 0 78a6.e13f.aac1
1/1/11 Up Forward Full 100M None No 1 0 78a6.e13f.aac2
1/1/12 Down None None None None No 1 0 78a6.e13f.aac3
1/2/1 Down None None None None No 1 0 78a6.e13f.aac5
1/2/2 Down None None None None No 1 0 78a6.e13f.aac6
1/3/1 Down None None None None No 1 0 78a6.e13f.aac7
1/3/2 Down None None None None No 1 0 78a6.e13f.aac8
mgmt1 Down None None None None No None 0 78a6.e13f.aab8
SSH@ICX7150-C12 Switch#

[MiSNemesis]

Supposed to be Disabled?

[Imran_ruckus]

Hi @MiSNemesis 

Thank you for the response.

Could you please enable, apply, save and check once? (Please refer to the below screenshot)

Please check and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.