When statically configuring bandwidth, will the lower bandwidths still be supported?For example if i configure 40MHz, will 20MHz only clients still be allowed on the WLAN? 80MHz will no longer be used in this case?Br.Koen
Found a table for the old AP's. Is there also 1 available for the R & T types?
I currently have two sites connected by a layer 3 network. At each site L3 switches route the traffic. At the main site i have a ZD setup and APs connected to the same layer 2 network ( Vlan 1 - management) - 192.168.5.X/24 - This is fine the Wireles...
Does zoneflex r300 support client mode or repeater?
I have a 7982 that I just pushed a firmware update to. Sorry for not paying attention to the firmware number, it was done via the FTP option. The firmware update completed, and I was able to get back into the UI after it was done without a problem. I...
