Hi, I'm trying to get my 7372 APs to connect to our vSPoT instance via a ZoneDirector 1100. We are running the latest firmware on the ZD and APs i.e. 9.10.0.0 build 218. Everything looks configured correctly but I get the following on the ZD Monit...
Is there any other way to connect zoneflex and another router just to make it link?Thank you!
When statically configuring bandwidth, will the lower bandwidths still be supported?For example if i configure 40MHz, will 20MHz only clients still be allowed on the WLAN? 80MHz will no longer be used in this case?Br.Koen
Found a table for the old AP's. Is there also 1 available for the R & T types?
I currently have two sites connected by a layer 3 network. At each site L3 switches route the traffic. At the main site i have a ZD setup and APs connected to the same layer 2 network ( Vlan 1 - management) - 192.168.5.X/24 - This is fine the Wireles...
