RUCKUS Indoor and Outdoor Access Points (APs)

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

Dynamic VLAN with 2 LAN Ports

Hi,I have tested dynamic vlan using R500 with Microsoft NPS and works perfectly fine. So new we are planing to add few more APs from R710. with R710 we are gong to connect both the LAN ports for better performance.I have few questions to verify.1) Ca...

Having issues with R720's negotiating with Meraki 350X 2.5Gb ports.

This is a new issues, as ive never had a problem with a 2.5G linking up before. I would assume its likely from the Meraki side. I thought id run it past this community to see if anyone else is having issues, or have possible any thoughts on the issue...

A poor throughput performance standalone AP with NAT forwarding.

I have tested throughput test with NAT forwarding for Ruckus AP and some vender APs.On Nat-forwarding, Aruba(IAP mode)and Samsung AP(standalone mode) have over 300Mbps at throughput test, but Ruckus AP have just 150-200Mbps.Using same Ruckus AP, when...

Mesh APs not working after a Failover

Good day! Our topology consists of two Zone Director 1200 : One as a primary and the other one as a secondary. Ive configured the smart redundancy in both controllers, making the primary active and secondary as a standby. We have wired aps, that are...

vSZ-E with R510 - Maximum clients

Hello, based on KBA-4666 I would like to know if anyone knows the values for R510 which doesn't appear on the table. I have a Virtual SmartZone Essentials with R510 APs, is that table applicable on this scenario?

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

2

1

1

1

1