RUCKUS Indoor and Outdoor Access Points (APs)

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

Resolved! H510 Access Point Command Line Question

HiIs it possible to get the MAC address of wired client using the command line of a Ruckus H510 Access Point?The H510 has 4 wired LAN ports.I noticed that the command line has several 'get' commands available. But not sure if one of the get commands ...

Ruckus R710

I purchased an 901-R710-US00 and wish to configure it as a stand alone AP.I downloaded the FW of rcks_fw_R710_100_2_1_0_148.BL7 file.Tried to upgrade the R710 to this firmware and am getting "AP image signing : Incompatible Image"Can somebody please ...

Heartbeats loss message from AP between ZD

I have 6 AP(R510, R610) join to ZD1200 but after connect a few minutes, it will shown "AP disconnect reason: Heartbeat Loss"AP and ZD are both online and can ping to each other, firmware also same 9.13.3.0 build 41I have try to power cycle ZD then th...

R510

HelloI have Ruckus sz144 controller running on 6.1.2 and ruckus AP R510 .The Ap is getting IP address from the DHCP, but not connecting to the controller.I am also not able to access the AP GUI and even resetting the AP, I ma not able to get to the ...

Problem with WT41N0 Motorola RF Guns and Ruckus ZF7372-E AP

Good evening,I have a problem in warehouse environment. We have an access points Ruckus ZF7372-E and working with STAs Motorola/Symbol WT41N0 RF guns (Windows embedded onboard). Client always goes to error "Radio reset" and then it need to reboot the...

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

2

1

1

1

1