CommScope RUCKUS Community Forums

frnkblk · 12-11-2024

Why don't I see my telnet and SSH sessions showing here?telnet@router#show telnetTelnet server status: EnabledTelnet connections:telnet@router#show ip ssh sessionsSSH server status: EnabledSSH connections:SSH connections (inbound):SSH connections (ou...

frnkblk · 09-08-2023

Last night we experienced several systems on our three-member ICX7450 stack:alarms about BGP sessions bouncingcould not SSH in via inband or OOB interfacesreceived alerts from some attached devices that some LACP-enabled LAGs bounced a few timesSNMP...

frnkblk · 02-23-2023

I have a pair of stacked ICX6610's running FCXR08030t.bin where the "ip igmp group-membership-time" switches several times per day from 275 to 145 and the back again. Our router configuration monitoring system automatically identifies this.Any idea h...

frnkblk · 09-27-2022

After upgrading from 9.0.0. to 9.0.1c the 40G stacking ports stayed down on two-member ICX7450 stack and after upgrading. These were 40G modules in the rear of the unit, in slots 3 and 4. We had unit 1 module 3 wired to unit 2 module 4.Despite the ...

frnkblk · 08-05-2022

I scoured the documentation but could not find it -- how do I configure an enable password in version 9.0? Every time I SSH into our switches and go into enable mode I get a warning:SSH@router>enNo password has been assigned yet...SSH@router#Frank

frnkblk · 12-13-2024

So after attempting to use the Ethernet management port, and then switching back, it now works, showing the active SSH and telnet session I have in place.telnet@router#show ip ssh sessions SSH server status: EnabledSSH connections:SSH connections (in...

frnkblk · 12-12-2024

I just completed the upgrade -- no change:SSH@router#show ver | inc 090UNIT 1: compiled on Nov 12 2024 at 22:26:36 labeled as SPR09010j_cd6(33554432 bytes) from Secondary SPR09010j_cd6.bin (UFI)UNIT 2: compiled on Nov 12 2024 at 22:26:36 labeled as S...

frnkblk · 12-12-2024

I agree, it does seem like strange that not more people are seeing this.We're planning to upgrade to 9010j_cd6 -- I'll update this group with the results once that's done.

frnkblk · 12-12-2024

I can't log into the original router rihgt now, but when I do a "show who" on another 7450 running switch code (SPS09010c.bin) it doesn't work, either.I'm SSH'd in via the mgmt port -- I see a logged in user on the serial port (that's fine), but not ...

frnkblk · 12-06-2023

I’ve had the same issue, could not find resolution, so stacked with 10G ports.

CommScope RUCKUS Community Forums

User Statistics

User Activity

Don't see active telnet or SSH sessions

High CPU on ICX7450 running 09.0.10f

Self-changing ip igmp group-membership-time

40G stacking ports stayed down on two-member ICX7450 stack and after upgrading from 9.0.0. to 9.0.1c

Configuring an enable password on ICX7450 in 9.0

Re: Don't see active telnet or SSH sessions

Re: Don't see active telnet or SSH sessions

Re: Don't see active telnet or SSH sessions

Re: Don't see active telnet or SSH sessions

Re: ICX 7450 40Gig Stacking/Uplinks not possible