Can I configure SZ100 ports on different network rather on different subnets
Can I configure SZ100 ports as P1 and P2 on 192.168.11.0 for Management and AP control and P3 and P4 on another network like 172.16.0.0 for AP Data
Forum Posts
Moving to new ZD1100 , 7363 AP firmware not updating
We have had problems with our ZD1100 (9.1.0.0 build 23) so acquired another ZD1100 (9.8.2.0 build 15). unit. The new ZD was manually setup identically and the original turned off. The access points were set to approve and we could see them on the ne...
I want to create 3 SSID with separate 3 VLAN like Cisco WLC is it possible in Ruckus Zone Director.
Hi,My present setup is like that my Zone Director and AP and same VLAN and i have 3 SSID, all are getting IP address from DHCP same pool which i configured for that VLAN. Now I want to create 3 seperate VLAN for that 3 SSID and map with the same like...
Support Tech pointed out that Ruckus does not officially support iOS Safari
Today after 2 hours, when a support tech couldn't figure out why ipads time out after authentication he pointed me to page 16 of the zone director user manual 9.10 and highlighted "Not Officially supported browsers - Safari, Dolphin, Opera Mini, Andr...
AP don ́t show SSID ́s in sz100
Hi guys,nice to talk to you again, we are configuring a sz100 with aps models r500, r600 and t300, the version of sz100 is 3.1.1.0.476 but we have a problem: ap ́s don ́t show the ssid ́s that is configured in the controller.when i clicked monitor-ac...
Related Self-Help
