Unleashed
RUCKUS Unleashed enables controller-less Wi-Fi architecture for small business environments with superior performance, lower costs and simplified management.
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Master / Standby Failover Design within SmartMesh Network

Hello,i am planning a SmartMesh Network with Ruckus Unleased.I have two wired APs and seven non-wired APs (big Parking Area without Cabling).The wired APs will be the Root-APs.My questions:- How many Hops are supported with SmartMesh within an Unleas...

AP Certificate Refresh

My question is regarding the AP Certificate Refresh which is required prior to November 2016.I have a 100's of Zonedirector and Virtual Smart Zone installations out in the field  and I just wanted to confirm what exactly is going to be affected?As I ...

jas_buray by New Contributor II
  • 3200 Views
  • 5 replies
  • 1 kudos

VoIP on Unleashed

I have a small network set up with three R500s Unleashed. I am trying to use a VoIP service as the client has poor cellular coverage. When I try to make a call I am getting an error message that I have a weak signal even though in the dashboard is ...

How to config Cisco SG300 connect R500 unleashed

Hi ,  i have problem can't access SSID Guest i have config Cisco SG300 connect to R500 (Config unleashed) SG300 ----> in fa 21----->Trunk allow vlan all(untage vlan 1 , Tag vlan 10,20,30) -------> AP R500and i have config ip helper address for all vl...

LED indicators showing 2.4 and 5Ghz signal is down

Hi, I have a couple of R310 unleashed and I'm seeing the LED indicators for either 2.4Ghz or 5Ghz not lighting up even though I'm standing right next to the AP with my device. What could be causing it? My device supports both 2.4Ghz and 5Ghz connecti...

Announcements

Welcome to RUCKUS Community!

Please be sure to read the Community Guidelines before posting.

Please visit the Help FAQs if you are new!

Lennar SmartHome Customers

Please visit our Lennar Knowledge Base for quick answers to common issues before posting to the forum.