We have a server setup with the VM and Ruckus Smart Zone. I am in the initial CLI setup. I login and type 'setup'. The reply is "Network is not ready! Please try again later. % Failed to setup!"
I can't get past this.
Please share the vSZ firmware version and VM machine details on which you are setting up, I would suggest to verify that the network interfaces are mapped correctly on the VM for the vSZ and retry in sometime.
Also, please make sure you have correct hardware resources allocated to the VM.
For 5.x version you need, CPU : 2-4, RAM: 13 GB, HDD: 100 GB.
Starting from 6.0, you need CPU: 2-4. RAM : 13 GB, HDD : 150 GB.
6.0 and 6.1:
Above is the recommended settings. Please refer upgrade guide if you have more APs to manage and match the
We were using VirtualBox which is not supported.
Now we have CentOS using KVM for virtualization.
When I open the Ruckus CLI I cannot get past the login screen.
vSZ-D login: admin
Cycles back to vSZ-D login:
If I enter any other username or password I get "incorrect login"
These are default password for vSZ-D.
Based on the the guide, you have to change the admin password at Step:17, hope you have changed the password to a newer value, If you forget your password you will need to resetup vSZ-D.
I hope you have already setup your vSZ, if your vsZ-D is approved on the vSZ, it will take same password as vSZ.