07-21-2022 11:48 AM
We have a server setup with the VM and Ruckus Smart Zone. I am in the initial CLI setup. I login and type 'setup'. The reply is "Network is not ready! Please try again later. % Failed to setup!"
I can't get past this.
07-21-2022 03:35 PM
Please share the vSZ firmware version and VM machine details on which you are setting up, I would suggest to verify that the network interfaces are mapped correctly on the VM for the vSZ and retry in sometime.
07-25-2022 07:16 PM - edited 07-25-2022 07:28 PM
Also, please make sure you have correct hardware resources allocated to the VM.
For 5.x version you need, CPU : 2-4, RAM: 13 GB, HDD: 100 GB.
Starting from 6.0, you need CPU: 2-4. RAM : 13 GB, HDD : 150 GB.
6.0 and 6.1:
Above is the recommended settings. Please refer upgrade guide if you have more APs to manage and match the
07-22-2022 12:05 PM
We were using VirtualBox which is not supported.
Now we have CentOS using KVM for virtualization.
When I open the Ruckus CLI I cannot get past the login screen.
vSZ-D login: admin
Cycles back to vSZ-D login:
If I enter any other username or password I get "incorrect login"
07-22-2022 12:35 PM - edited 07-22-2022 12:36 PM
These are default password for vSZ-D.
Based on the the guide, you have to change the admin password at Step:17, hope you have changed the password to a newer value, If you forget your password you will need to resetup vSZ-D.
I hope you have already setup your vSZ, if your vsZ-D is approved on the vSZ, it will take same password as vSZ.