cancel
Showing results for 
Search instead for 
Did you mean: 

Where is the “engineer”

Jhiggins91
New Contributor

Apparently I need a “engineer” to tell them I need my equipment replaced so where is this “engineer”

21 REPLIES 21

IMG_3353.jpeg

IMG_3352.jpeg

My access points do not have power. My switch has a green light and an amber light. I tried all the guides to reset it none have worked. I hooked up the usb to c cable and was able to get connect to the switch however all I got was a bunch of lines like it was on a never ending load. I will attach images. I at this point am thinking I need it all replaced. 

Hi @Jhiggins91 

Thank you for the detailed information you shared.

As you mentioned there are lights on PWR and SYST, if there is an amber/orange light on the "SYST" and a green light on the "PWR" on the Switch (as it is in the below picture). Meaning the Switch is stuck in the boot mode.

Basically, due to the power outage/ power spike, the switch went to a state that we call ‘boot mode’ that is not able to boot up properly. 

Please follow the below steps to fix this issue:

As you mentioned that you tried reset, Once again we will try to reset the Switch as described below:

1. Please try to disconnect from the Power outlet the ICX-7150 and reconnect.

2. Please try to press the reset button using a paper click or a small stick 

  • Remove power from the switch.
  • Press and hold the Reset button while applying power to the switch.
  • After all the system LEDs flash amber, release the Reset button.

IF RESET IS NOT WORKING, PLEASE TRY TO RESET YOUR SWITCH MULTIPLE TIMES (Like 10-15 times) AS DESCRIBED ABOVE.

 

IF STILL RESET DOESN’T WORK: Please follow the below steps.

If the reset does not make any difference, we need to perform a software recovery since it can be that the image flash is corrupted in basic words the unit is not able to boot up properly and need re-install the image to boot up properly.

Below is the Guide and Video Link to perform the Software recovery process:

Please refer to the below guide and Video link: 

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-a-Software-re...

Video Link: https://www.youtube.com/watch?v=Ql22blH_CGo

Please let me know if you have any queries in this regard.

Thank you again for your patience.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

IMG_3373.jpeg

As I said before I already tried this. This is all it would do

Also GitHub isn’t even a working site so try again

Hi @Jhiggins91 

Greetings!!!

Thank you for the response and the information.

Please try to access CLI using Putty Application.

Please let me know if you have any queries in this regard.

Thank you again for your patience.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.