Thank you for the response.
Apologies for the inconvenience caused.
Could you please let us know if you have performed the factory reset of the Access Points as described in the earlier posts? (Sharing it once again below)
Please read the following guide for the same:
IMPORTANT NOTE: As you have multiple Access Points (APs) in your house, please make sure you only keep the affected/configuring AP On and reset the same. Please go to the Ruckus Switch (located in the panel) and disconnect from its ports the Ethernet cables of the other Access Points, except the one that you are going to work with. Later you could connect other APs.
Physical Factory Reset of RUCKUS Access Points:
Ruckus Unleashed Set-up using your Mobile:
Please refer to the below Video for the initial setup which also includes resetting of Username and Password.
Ruckus Unleashed Set-up using Web:
Password recovery setup:
Please let me know if you have any queries in this regard.
Thank you again for your patience.
Lennar Home Community.