12-22-2022 05:56 PM
Hello,
I have a Lennar home and I noticed that on my Unleashed app my switch is not labeled in the switch icons of my app? Is there a reason for it? I believe that the person that configured it, configured my home incorrectly.
Solved! Go to Solution.
12-27-2022 07:51 AM
Hi @LtBorikua
Please use the same password that you used to log in via putty if that does not work I will leave you a short guide :
In order see the ICX in the unleashed app is a bit tricky because you must generate a ssh tunnel so in simple words is like private tunnel between the access points and the ICX.
1-Make sure the Switch is on version 8090+ later ( you are done with this since you are running 8095g )
2-Make sure the management approval is enabled
3- It would be great if you enable LLDP/RSA protocol on the switch side here is the commands:
Device>enable
Device#config terminal
Device(config)#lldp run
Device(config)#crypto key generate rsa
Edit the current password and username
device(config)# username super password pass
Where the username is ’super’ and password ‘pass’
Unleashed dashboard
1-Hit Add on that dashboard
2-Put the IP address of the ICX switch
3-Username and password for Switch authentication that we created
To sync the data, it will take us a while, so after a couple of minutes it should say connected
Best Regards
Fernando Vasquez
12-27-2022 09:14 AM - edited 12-27-2022 09:14 AM
Same to you !!! It was a pleasure to assist you ! Happy Holidays !
Best Regards
Fernando Vasquez
04-20-2024 04:43 PM
The links in the original answer are both broken.
04-22-2024 05:55 AM
Hi @KenB2386
Greetings!!!
Thank you for contacting the RUCKUS Community forums.
As this case was raised by @LtBorikua which is old and now closed.
Please raise a new post with a detailed description of your network issue on RUCKUS Lennar Support
Thank you again for your understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.