CommScope RUCKUS Community Forums

I have upgraded the switch to SPS08095g as recommended for Lennar homeowners.The R510 AP is working.The show inline power command for port 1 where the Ring doorbell cable is connected shows its state is OFF and says PD Detection Fault is the ERROR. W...

I was able to get back to the switch today. Fortunately it had an IP address. I was able to telnet to it and was not getting the flood of error messages there. That is, not until I executed the command to copy in the new bootram image and then the sa...

My smarthome was built in May 2018 and includes this switch, 2 R510 APs, and a Ring doorbell. I installed a Netgear R6400 router before the Amazon tech installed the smarthome package. I have added additional ethernet drops but all the original cabli...

I have one of the first 2018 Lennar smarthomes in our community with this switch, 2 APs, and a RING doorbell. They worked fine for 5 1/2 years and I had never tried to check anything until now. It appears to be running 2017 switch firmware.This winte...