Hi @thead
Seems that your switch may present some PoE issue (power over Ethernet)
To solve this you must access the command line of the Switch and do some diagnostics
1-For this we must locate the IP address (this is a logical address assigned by your local router (ISP) to the switch) I will leave a quick guide:
How to find my Ruckus “Devices IP address” using free applications
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-find-my-Ruckus-Device...
2-After that we must remotely access to device, I leave a guide on how to access to the switch
Here is a quick guide how to access via CLI of the devices
How to remotely access to 'ICX 7150-12P' or 'access points' "Network devices"
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-remotely-access-to-IC...
If you can access to the Command line should look like this
ICX7150-C12 Switch>
3-Write the following commands:
Note: Hit Enter to accept each command:
ICX7150-C12 Switch>enable
ICX7150-C12 Switch#show version
ICX7150-C12 Switch#show inline power
ICX7150-C12 Switch#show inline power detail
Copy and paste the results on the chat (here)
If you cannot access via IP we can access physical using a console cable
How to console in the ICX-7150-C12p
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-console-in-the-ICX-71...
Once you are log in via console go to the Step '3'
Best Regards
Fernando Vasquez
