07-10-2023 08:10 AM - edited 07-10-2023 08:18 AM
I have a ICX 7150 since 2020 and was never upgraded. I am at a lost as to how to locate the version and then what upgrade is necessary to use. Any help would be appreciated.
Solved! Go to Solution.
07-10-2023 08:30 AM
Hi @MiSNemesis
The recommended firmware version for ICX 7150 Switch is SPS08095dufi.bin
Please follow the below guides to perform an upgrade to the code 08095g UFI and upgrade both partitions with the switching code file named SPS08095gufi.bin to avoid the issues in future.
1.Upgrade a Switch ICX-7150-C12P using a USB flash drive
2. Upgrade a Switch ICX7150-C12P via TFTP
3. Upgrade a switch via Web GUI (ICX7150 Switch)
Please let us know if you have any queries in this regard.
Best regards,
Jayavidhya
Lennar Home Community
07-10-2023 05:06 PM
I did the above and nothing changed with the APs.
07-11-2023 06:12 AM
Hi @MiSNemesis
Please let us know how many access points are connected to the switch.
Please share the image of the access points as mentioned below.
Here is where you can upload the image/photo :
you can also drag it to the chat
Also please check whether the devices are connected properly by using the below link.
Most common Setups for Lennar homes users
Best regards,
Jayavidhya
Lennar Home Community
07-11-2023 06:30 AM - edited 07-11-2023 06:31 AM
I have 2 Access points. I believe they are the R510 APs.
07-11-2023 06:32 AM
Please note that this was always working. Nothing was changed physically other than the updating the Switch.
07-11-2023 07:09 AM
Hi @MiSNemesis
For further troubleshooting please share the output of the following commands
"Show inline power detail"
Please let us know if you have any queries in this regard.
Best regards,
Jayavidhya
Lennar Home Community