cancel
Showing results for 
Search instead for 
Did you mean: 

Firmware Upgrade for ICX7150-C12 Switch - Need help locating Firmware version and help upgrading

MiSNemesis
New Contributor

I have a ICX 7150 since 2020 and was never upgraded.  I am at a lost as to how to locate the version and then what upgrade is necessary to use.  Any help would be appreciated.

1 ACCEPTED SOLUTION

Jayavidhya
Moderator
Moderator

Hi @MiSNemesis 

 

The recommended firmware version for ICX 7150 Switch is SPS08095dufi.bin 

 

Please follow the below guides to perform an upgrade to the code 08095g UFI and upgrade both partitions with the switching code file named SPS08095gufi.bin to avoid the issues in future.

 

1.Upgrade a Switch ICX-7150-C12P using a USB flash drive

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

 

2. Upgrade a Switch ICX7150-C12P via TFTP

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

 

3. Upgrade a switch via Web GUI (ICX7150 Switch)

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-an-Upgrade-vi...

 

 

Please let us know if you have any queries in this regard.

 

Best regards,

Jayavidhya

Lennar Home Community

View solution in original post

36 REPLIES 36

I did the above and nothing changed with the APs.

Hi @MiSNemesis 

 

 

Please let us know how many access points are connected to the switch.

 

Please share the image of the access points as mentioned below.

 

Here is where you can upload the image/photo :

 

you can also drag it to the chat

 

Also please check whether the devices are connected properly by using the below link.

 

Most common Setups for Lennar homes users

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Most-common-Setups-for-Lenna...

 

 

 

 

 

 

Best regards,

Jayavidhya

Lennar Home Community

 

20230711_132448768_iOS.jpg20230711_132523740_iOS.jpg20230711_132531356_iOS.jpgI have 2 Access points.  I believe they are the R510 APs.  

Please note that this was always working.  Nothing was changed physically other than the updating the Switch.

Hi @MiSNemesis 

 

For further troubleshooting please share the output of the following commands

 

"Show inline power detail"

 

Please let us know if you have any queries in this regard.

 

Best regards,

Jayavidhya

Lennar Home Community